GC G-BOND REFILL
Description
G-BOND is a new, revolutionary 7th Generation (single component) adhesive that takes the guesswork out of bonding. The unique combination of Phosphoric Acid Ester Monomer and 4-MET Adhesive Technology creates superior etch and adhesion to enamel, in addition to providing a chemical and mechanical seal to dentin (referred to as the Nano Interaction Zone)
- 7th Generation Bonding Adhesive
- Single component
- Etch, desensitize, prime and bond in as little as 20 seconds
- Not technique sensitive like other “all in one” bonding systems
- No post-op sensitivity
- Fast and easy application
- Strong, reliable, and consistent bond
- Stable material; simple storage
Features
- 7th Generation, one bottle, one coat only adhesive
- Mild etching of enamel and dentine
- Tubules to stay closed providing a very low risk of post-operative sensitivity
- Simultaneous demineralization and monomer infiltration results in a better seal resulting in less nano-leakage
- One component system with a simplified application technique saves time - a 30 second procedure
- Extremely stable formulation, oral durability guaranteed.
- No water uptake
- No discoloration
- No loss of retention
Key Specifications
PRECAUTIONS
- G-BOND is flammable. Do not use near naked flame. Keep away from sources of ignition. Do not store large quantities in one area. Keep away from direct sunlight.
- G-BOND is volatile. Use in a well ventilated place.
- In case of contact with eyes, flush immediately with water and seek medical attention.
- In case of contact with oral tissue or skin, immediately remove with a sponge or cotton pellet. After the restorative treatment is finished, rinse thoroughly with water.
- If the tissue contacted by the material turns white or forms a blister, advise the patient to leave the affected area undisturbed, until the mark disappears, usually in 1-2 weeks. To avoid contact, it is recommended to apply cocoa butter to the area where rubber dam cannot cover.
- Avoid inhalation or digestion of material.
- When spilt on the table or floor, immediately wipe off with a dry cloth.
- Do not mix with other products.
- Dispose of all waste according to local regulations.
Packaging
Kit Contains
- 1 x 5ml bottle
- 50 x Micro-tips
- 1 x Micro-tip Handle
- 1 x Dispensing dish
Subscribe by Email
Follow Updates Articles from This Blog via Email
No Comments