GC SOFT LINER
Description
For the temporary rebasing (relining) of acrylic dentures. Tissue conditioning.
Key Specifications
CONTRAINDICATIONS:
MULTI-USE DELIVERY SYSTEMS:
Do not use on patients with known allergy to acrylic resins. In case of allergy, refer to a physician
CLEANING AND DISINFECTING
MULTI-USE DELIVERY SYSTEMS:
To avoid cross-contamination between patients this device requires mid-level disinfection. Immediately after use inspect device and label for deterioration. Discard device if damaged.
DO NOT IMMERSE:
Thoroughly clean device to prevent drying and accumulation of contaminants.
Disinfect with a mid-level registered healthcare-grade infection control product according to regional/national guidelines.
Disinfect with a mid-level registered healthcare-grade infection control product according to regional/national guidelines.
Packaging
1-1 package:
- 1 x 100g powder
- 1 x 100g (97mL) liquid
- Accessories
Direction to Use
1. PREPARATION
a) Clean the contact surface thoroughly using pumice and water and abrade the area to be relined.
2. MIXING
a) The standard powder/liquid ratio is 2.2g/1.8g, (first graduation on powder measure to 4 graduations of the liquid syringe).
a) Clean the contact surface thoroughly using pumice and water and abrade the area to be relined.
2. MIXING
a) The standard powder/liquid ratio is 2.2g/1.8g, (first graduation on powder measure to 4 graduations of the liquid syringe).
Note:
Consistency may be varied by changing powder/liquid ratio.
Consistency may be varied by changing powder/liquid ratio.
b) Measure into the glass jar and mix for 30-60 seconds.
3. RELINING
a) Coat the mixture onto the denture as evenly as possible
b) Insert the denture in the mouth, muscle trim and retain it in the centric occlusal position for 4-5 minutes.
c) Remove and inspect for defects.
d) Dip the denture into cold water, and trim away excess at the periphery with a heated sharp instrument.
a) Coat the mixture onto the denture as evenly as possible
b) Insert the denture in the mouth, muscle trim and retain it in the centric occlusal position for 4-5 minutes.
c) Remove and inspect for defects.
d) Dip the denture into cold water, and trim away excess at the periphery with a heated sharp instrument.
Subscribe by Email
Follow Updates Articles from This Blog via Email
No Comments